Bearing Packer Technical Information

1.	Place yellow tube adapter on base of grease tube.

2.	Ensure black gasket is in place in yellow outer cone.

3.	Slide the blue sleeve over the grease tube.

4.	Insert the piston into the grease tube and screw the yellow cap onto the blue sleeve.

1.	Insert the Bearing Packer and place on a level work surface.

2.	Remove the blue lid and blue cone plug.

3.	Place the bearing and the cone inside the Bearing Packer as shown.

4.	Apply downward pressure ONLY on the blue cone, until bearing is greased sufficiently.

5.	Lift the bearing out using the blue cone plug and repeat for each bearing.
6.	When all bearings have been packed, remove the grease from the yellow cone and use the grease to pack the bearing hub.
7.	Place the blue cone plug back into the yellow cone to seal the Bearing Packer.

8.	Replace lid on cone to protect from dust and dirt.

1.	Invert the Bearing Packer and place on a level work surface.

2.	Select a plate to suit the bearing from the four plates supplied with the Bearing Packer.

3.	Place the plate and bearing into the yellow cone. Clamp fingers firmly against yellow cone as shown.

4.	Apply pressure with fingers to inner race of the bearing. The plate will rise on the grease. Take care to ensure the plate is centered and adjust if necessary.

5.	Press the entire Bearing Packer downwards until the bearing is adequately greased.
6.	Repeat process with next bearing.
7.	When all bearings have been packed, remove the plate and wipe the grease off into the outer cone.

8.	Store plate plug back in clam shell. Replace lid on cone to protect from dust and dirt.